There are several reasons for your tumble dryer to stop partway through a programme. Please see if one of the following will solve the problem.
See if the water tank is full
If your tumble dryer isn’t plumbed in, it will have a water tank where it stores the water removed from wet laundry. This tank should be emptied after each drying cycle.
If you do not empty the water tank, your tumble dryer may stop during the next drying cycle because the tank is full. If this happens, you’ll need to pull out the water tank and empty it before the tumble dryer resumes operation.
To empty the water tank, pull it out of its housing at the top left of the appliance. Pour the water out. If there’s lint in the tank, clean it under the tap with warm water.
Check the drive belt for damage
Open the door and try turning the drum with your hand. If it turns with no resistance at all, your appliance’s drive belt may be damaged or broken. In this case, please contact an authorised service agent.
Consider electrical failure
Your tumble dryer may have stopped due to an electrical spike or a malfunction. Try unplugging your appliance. Wait for a minute and then plug it back in. Try running a programme again.
Consider technical problems
If all else fails, your tumble dryer might have a technical problem. If you suspect this to be the case, contact an Authorised Service Agent.